The TMD-B is loaded with the smoke charge KM768 to the lower of the body. Either a fuze MV-5 for practicing or a pull type firing device connected upper and lower of the body and then it is operated by an observer or by a trip wires. The fuze is ignited the smoke charge and the mine is emitted yellowish or white smoke.

After the PMD-57 is loaded with the smoke charge KM765
in the smoke charge case and connected primer in fuze
MUV-2 for practicing, the PMD-57 assembly is ignited
the smoke charge under vertical loading ofthe pressure
ring of from side load effects on the tilt rod. At this time,
bursting-sound and white smoke is accured.

After the POMZ-2 is loaded with the smoke charge KM764 to the body, combined fuze MUV-1 for practicing to the body assembly and the POMZ-2 assembly is ignited the smoke charge under vertical loading of the pressure ring of from side load effects on the tilt rod.
At this time, bursting-sound and white smoke are occured.

This mine uses the mechanical pressure type fuze.
After connected the smoke charge to the body, the fuze of the mine is ignited the smoke charge by a actuation the pressure plate is forced downward or by a pulling of the booby trap.
This initiates the smoke charge in the bottom of the fuze.

After the KM16 mine is connected the smoke charge to the fuze KM605, the mine is ignited the smoke charge under vertical loading in the top of the fuze or by a pulling of the pull ring attached trip wire.

The TM-46 is loaded with the smoke charge KM768 to the lower of the body. Either a fuze MV-5 for practicing or a pull type firing device connected upper and lower of the body and then it is operated by a pressure or by a trip wires. The fuze is ignited the smoke charge and the mine is emitted yellowish or white smoke.

After connected the smoke charge and the fuze KM607 to the K441 body, the fuze is actuated by a loading of the pressure ring or from side load effects on the tilt rod.
At this time, bursting-sound and smoke are occurred.

After insertion the smoke agent KM753 to the mine body KM18A1, and be used with the electric blasting cap, practice KM752. When
be fired with firing device, electrical, KM57 appear the smoke and sound.

With mine set on "A" and safety clip removed by pulling a force applied to the pressure plate will depress the belleville spring. At this time, the mine is ignited the smoke charge by driving the firing pin.

This mine uses the mechanical pressure type fuze.
After connected the smoke charge to the body, the fuze of the mine is ignited the smoke charge by a actuation the pressure plate is forced downward or by a pulling of the booby trap. This initiates the smoke charge in the bottom of the fuze.

After these sub-caliber cartridges are loaded in the KM1 sabot and it is fired by the same method as actual mortar(4.2inch) and then it make flight for a constant distance which eject bursting-sound and smoke at the target area.

After these sub-caliber cartridges are loaded in the KM1 or KM3 sabot and it is fired by the same method as actual mortar(60/81MM) and then it make flight for a constant distance which emit bursting-sound and smoke at the target area.